-
Hi, thanks for the library. I am experiencing some issues, is I go to device folder and run cat w1_slave command I get this result.
3d 00 4b 46 ff ff 07 10 b2 : crc=b2 YES
3d 00 4b 46 ff ff 07 10 b…
-
The attached simple flow, with an inject node driving a DS18B20 node and on to a function node and MQTT Out, works correctly. The Wemos D1 Mini has a DS18B20 connected in the normal manner, 0V, 3,3V a…
-
I have an MS-103 temperature control module from Moes, and I flashed it with OpenBK, which is great. Thank you for your work. However, I have an issue that I cannot drive the temperature probe. The pr…
-
I use the homekit with 3 sensors DS18B20 and the device is no longer reachable in the homekit every 4 hours. It must then always be registered again. What could be the problem here?
-
I am trying to setup a value that I can reuse in config.
I have multiple sensors and would like them all to have the same interval value.
So I tried to use Jinja2, but the config does not load.
…
-
I'm using a ESP with Tasmota firmware and it outputs the response in this format:
`{"StatusSNS":{"Time":"2018-09-08T17:34:50","Switch1":"OFF","Switch2":"OFF","DS18B20":{"Temperature":25.8},"TempUn…
-
Hi, I ve a question. Which Dallas OW-Sensors are supported? Only DS18B20 or others like DS2438 with p.e. additional humidity-sensor too? Or, is it possible to use the sensors offered here: https://www…
-
I need micro:bit v2 micropython .py library files for the onewire protocol and DS18B20 driver for a waterproof temp sensor. Research has been frustrating. Has anyone ported this yet.
I took a look …
-
Arduino IDE 2.2.1 all libraries updated to current available.
Attempting to run a DS18B20 Dallas Semiconductor temp sensor on the "I2C" JST connector of a LilyGO T-Display S3.
The reading was -127 w…
-
Hi, is there a possibility for quick fix to read more precise temperature from DS18B20? For now i'm getting just integer. It would be great to get double value.