-
Balun T4 pin 1 is shorted to GND, but there should be a capacitor between pin 1 and GND. It is possible but tricky to bodge in a capacitor by cutting the GND trace and soldering a 33 pF 0201 capacitor…
-
Hi Chris,
Thank you for sharing your designs!
Going through the design files after I have encountered some electrical issues during integration, I have noticed that there is no GND line in the 25 …
-
Im [Skript](https://github.com/gbv/cocoda-winibw/blob/master/k10_cocoda.js#L68) wird das Feld `041A` für die GND ausgewertet, aber in den [Beispielen](https://github.com/gbv/cocoda-winibw/tree/master/…
-
### Version
Yosys 0.27 (git sha1 5f88c218b58, gcc 9.3.0 -fPIC -Os)
### On which OS did this happen?
Linux
### Reproduction Steps
```verilog
// test.v
module test(output out0, out1);
…
-
It would be great if some of the GPIO not used was broken out to some Test pads so we can add our own buttons as needed for example there is no way to use macros without a dedicated Macro GPIO set as …
-
As is mentioned: https://github.com/sinara-hw/Driver/issues/4, mDP cable has source and sink side, but unfortunatley it looks different than in design, should be like in the table:
| Driver | |…
-
In the ARDUINO_R3_ICSP device, the ground mapping is wrong.
You have
G$1.GND@1 GND@3
G$1.GND@2 GND@1
G$1.GND@3 GND@2
It should be
G$1.GND@1 GND@1
G$1.GND@2 GND@2
G$1.GND@3 GND@3
-
Hello!
Is freejoy support multiple button matrix on the same board?
The reason why I need that is because I have a 4 way switch, and I don't want put it with the 5*5 button matrix. But after I con…
-
Hello. I want to use this firmware with a module from aliexpress called YD-RP2040 (vcc-gnd.com), it has an additional button and an RGB diode. The diode is the same as the waveshare RP2040-Zero only o…
-
Hi,
I'm trying to set up 8 Femto Bolt devices to do synchronous capture, but triggered from an external source (raspberry pico).
I have connected the pico to one of the Bolts, through its VSYNC…