-
Is there a sample config.h where the si5351 board is running? I conncected a board to pin header of RS41 Ports 2 SDA and 3 SCL - see 3,8 volt on the VCC on si5351 - also set Si5351 CW on but see no si…
-
I'm considering implementing a frequency scan algorithm that requires precise control of when SPI writes to change frequencies are done.
If the frequency change is not done quickly enough, a m…
-
I tested FT8 and it works. However, there have been some issues where a wider pulse appears every time the symbol switches, which can contaminate the spectrum. And only after clicking "open" to open t…
-
**Is your feature request related to a problem?**
After each death respawn, no radio 343, no radio 152, no radio 117 can save the Settings (like channel, block, frequency etc.) before death(ACE envir…
-
Hello everyone,
I'm encountering an issue with my LoRa setup in the Australia region. Here's my setup:
Device: ESP32 with SX1262 Waveshare module
Gateway: Raspberry Pi 4 with SX1303 915MHz, usi…
-
This is definitely a "future directions" item rather than a current feature. Mario has invited me to document it for discussion.
My interest in the PSLab or something like it is largely about amate…
-
It would be great to add a flag to turboSETI to make it parse in a "frequency mask", a file with space-separated frequency channel numbers that the user wishes to ignore in the doppler search. These c…
-
Hi all,
my meters are equipped with ista radio net 3 modules (part no. 19320). From reading the [manual](https://www.ista.com/fileadmin/twt_customer/countries/content/Switzerland/Broschueren/Funk/P…
-
When viewing the spectrogram, particularly with a log frequency scale, it is difficult to determine the frequency of location. My application is for extremely low frequency, atmospheric radio signals…
-
### Is your feature request related to a problem?
Does the ESP32-C3 have a bias when operating the GPIO?I feel that when sending infrared, the deviation is very serious, resulting in AC control, and …