-
When I was running Marlin 2.0.7.2 (from the BTT repository), the system would play sounds at multiple pitches - when I would save settings, for example, it would play a three-tone beep to confirm the …
-
Hi everyone! I am very new to all of this and decided to install the BTT SKR mini E3 v1.2 board in my ender 3 pro. After install of the new board, my printer will not auto home. I think the X Y end-st…
-
### Description
CR-Touch doesnt Auto home properly using the marlin firmware.
I already tried adjusting some settings in the firmware.
defining USE_PROBE_FOR_Z_HOMING and BLTouchv
### S…
Loifu updated
6 months ago
-
### Description
On Auto-Home (and also via moving menu) the Z-Axis does not move back down anymore without the Z-EndStop.
With the EndStop switch plugged in it does move down.
### Steps to re…
-
after I switched from the orginal crealty mainboard to new mainboard BIGTREETECH® SKR MINI E3 V2.0 on both Ender 3 pro, the printer`s moves to the end at X axis, end the table also moves out after ea…
-
May I please get some help in configuring the ender3 v2 screen on the skr 2 board?
I've tried following this solution (https://github.com/MarlinFirmware/Configurations/issues/535#issuecomment-87301…
-
Could you kindly publish the configuration.h/configuration_adv.h for Ender 5 which was used to build the binaries for SKR-mini-E3-V3.0?
All you released are the ones for Ender 3
Thanks in advance
-
Please add PID bed tuning to the precompiled firmwares, it can make a huge difference in the quality of the prints
-
Printer is Ender 3 Pro,running SKR mini E3 V.2.0 with TFT35 touch screen
Issue:
When connected to PC to run PID noticed issue with TFT35 not showing current temperature when PID is running. Screen i…
-
### Description
I have upgraded fans on SKR MINI E3 V2 (Ender 3 Pro) with Noctua NF-Axxxx FLX 12V for the Hotend fan and also filament fan. I've installed Buck converter LM2596S to convert 24 to 12V.…