-
Hi, I am using your pcb and the same components, how to tune the antenna to 134khz?
-
Hi Stuart, I am trying to use your example code 23 tracker and 24 receiver for SX126X. The transmitter seems to be working fine but not the receiver. Despite the settings.h frequency being set to 4340…
-
### Description of the feature you're suggesting.
I have a key fob for opening a sliding door, that can't be read by flipper [Sliding_Door.zip](https://github.com/flipperdevices/flipperzero-firmware/…
-
Openwrt is good platform for integration.
-
If I understand your wiki completely, you're only dealing with 2 level of abstraction for the routing table.
As I understand it, it almost impossible to reach a node in a large network (let's say on…
-
Hello,
I'm new at Speeduino and i have to admit that i don't understand really much, but i will try to help to make it better.
Now i will tell u, which ideas i have.
1. Increase the speed from the l…
-
What is the intended way of setting a fixed spreading factor?
Should this be done in the library files, or in the Arduino Sketch?
-
Reading and cloning works fine. But emulation is not working for em4100 cards. It says simulating but the reader is not picking anything.
-
Setup Done
Output Getting
![Screenshot from 2024-01-18 17-30-…
-
I have a 2020 Toyota Proace City Verso and I would like to disable the start stop system. I found your project and I plan to build a small STM32 board that will send change sequences via the CAN proto…
byrrt updated
6 months ago