-
## Bug report
**Issue details**
I am not able to take off my 3 inch copter in loiter mode because I get no reading from rangefinder VL53L1X when standing on ground. Ground clear is 5cm, sensor…
-
As far as I am aware, the difficult parts of the job will be:
-1: designing a comfy outfit that works well with the sensors, and
-2: working with the sensors (perhaps there are nice libraries--but th…
-
Hello,
I'm interesting in exploring a solution to the power draw issue, but I noticed that the instructions were never updated for doing an SPI install. I may design a QSB for this, but it would be…
-
hi everyone, i can't get CC1101 to work with ii9341 display.
I am attaching the pins I used on the ESP32,
BUZZER PIN 13
SDCARD SD_MOSI PIN 23
SD_SCK PIN 18
SD_MISO PIN 19
SD_CS PIN 12
…
ghost updated
2 years ago
-
**Describe the problem you have/What new integration you would like**
I have some Wemos motor shield and I would like use for driving a fan. It's an I2C controler.
I've tried to using custom…
-
I'm trying to get this tracker software to work with a 360 degrees servo, no luck so far.
the servo only spins faster and faster.
can 360 servo support please be added if possible ?
-
You guys are smart enough to make some really neat products, but how on earth can you handicap this board by not making the most popular firmware used in this hobby work on it?
This is insanity, and…
-
#### Description
i cant make the z axis to go down ( it was working fine but something happined)
Z+ goes up
Z- goes up
changed the stepper motor
changed the stepper driver
changed to x axis s…
-
I have been following the development of your PicoSDK based C library with much interest. I have been thinking to switch out the lowest layers of the Arduino library that I just ported to use your C A…
-
This is brand new to me. All was working until the 3rd time I executed this job. My setup is smoothieboard with latest cnc config setup for grbl mode. I've tried multiple computers and multiple gcode …