-
```
The Pose Editor cannot display more than 18 servos on most netbooks (it
runs out of space)
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 29 Sep 2009 at 4:08
-
```
i have aproblem with starting pypose
i download python2.7,wxpython2.9 and pyserial
i install them when i try to start pypose i had this message
Traceback (most recent call last):
File "C:\Users\a…
-
```
1. Add an AX-S1 driver to the BioloidController Library.
2. Add an AX-S1 viewer to PyPose
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 6 Oct 2009 at 4:59
-
```
What steps will reproduce the problem?
1. Press "loop" button
2. Before loop is stopped, press loop again
3. PyPose hangs
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on…
-
```
The border area around the pose and sequence editors, under WinXP is a
darker color.
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 26 Sep 2009 at 2:29
-
```
Following this wiki page
:http://arbotix.googlecode.com/svn-history/r349/wiki/GettingSetup.wiki
= !PyPose Setup =
!PyPose is a pose and capture program, written in Python using wxPython. We of …
-
```
What steps will reproduce the problem?
1. I downloaded and installed pypose according to the installation instructions
on the pypose site
2. Tried to launch Pypose.py
3. Get the error below
Wha…
-
```
The EX-106 servo has a range of 12-bits, rather than 10, we need to do the
following:
# Allow PyPose to go up to 4095 for EX servos
# Select which servos are EX
# Adjust the radToServo() function…
-
```
What steps will reproduce the problem?
1. Build PhantomX Hexapod.
2. Load PyPose and run the "NUKE editor".
3. Assign servos to the labeled locations.
4. Capture limits and neutral poses.
To e…
-
```
What steps will reproduce the problem?
1. I downloaded and installed pypose according to the installation instructions
on the pypose site
2. I connected the computer to the ArbotiX board which ha…