-
Can we somehow separate all hardware specific stuff and run the flight controller only as an executable? I have done work simulating flight control for ardupilot controller (see video below demonstrat…
-
rxRefreshRate is the problem, this debug is showing the problem, rxRefreshRate is switching between 3 and 21ms, the actual refresh rate is 22ms, but AUTO substracts 1ms...;-)
Screenshot:
![snip](h…
-
Right now, I'm running a setup with Cleanflight and a Raspberry Pi that receives LTM telemetry from the FC and also sends MSP R/C commands to the FC. On the Pi, I use the same serialport for this. In …
-
### Should be:
According to specification, S.Bus output should be **SERIAL_8E2**.
## Is:
In OpenTX 2.2.1, Taranis X9D+, S.Bus output in transmitter bay on PPM pin is **SERIAL_8N2**.
-
Matek Systems F722-STD
1.9.1, 2.0.0 rc4
INAV/MATEKF722 2.0.0 Jul 14 2018 / 22:39:19 (f2cf315ad)
### Behavior
Cannot connect configurator to matek fc without connected battery. After I connect …
-
If you suspect this could be a bug, follow the template.
- What version of Dgraph are you using?
docker exec dgraph dgraph version
```
[root@nixos:~]# docker exec dgraph dgraph version
Dg…
-
As discussed in https://github.com/opentx/opentx/issues/2894#issuecomment-242977504 , there is interest in getting low-latency serial input for opnLRS TX modules to work.
This should be possible by r…
-
I've been trying to connect directly (hard wire) Taranis X9D+ to a Pixhawk flight controller (PX4).
I connected the PPM output pin within the Taranis external module thru a resistor based voltage div…
-
Hello
is something planned or in progress for FlySky i-Bus telemetry ?
-
Expanding on the DSM2/DSMX serial protocol that is already available but limited to 6 channels, I'd like to see some serial protocols available on the PPM output pin in the module bay. Specifically SU…