-
Hello is it possible to setup grbl so it can run core XY as it is one of the reasons to move to 32 bit.
If it isnt what would be the best alternative for 32bit core XY.
Also it seems that the cocox …
Sa6k0 updated
5 years ago
-
Hi there, I am a fan of what you've built here, it's a system I personally wish I had the time to do as well.. I would like to take advantage of your setup, however I am concerned of possible issues s…
-
Hi Andrew,
I'm a 3D printing beginner and just learned about your awesome Tuning Guide.
Under Pros for "45 Degree" Profile vs Standard Profile" you say "With CoreXY, 45 degree motions only use o…
-
You mention the following in homing-squence:
My question is: how will turning off the AB motors change the…
-
Hello @colinrgodsey
I see some comments about additional updates for this project noted in some of the issues. Are there any updates or planned updates?
I'm looking for CoreXY support. Marlin has…
-
Hello,
I built a CoreXY laser machine and I am using Mega2560+RAMPS combo with grbl-Mega 1.1f. I have a problem with homing. Simply put after initiating homing, only one motor moves at a time. That m…
-
I'm linking a PR I have prepared to deal with an issue I found with sensor-less homing.
After turning on my printer today, It was unable to home properly and moved itself into the front-left corner…
-
@Andypos you said that you have corexy machine, controlled with Nucleo board.
Do you have problem with homing ($H)?
Mine just goes to +x limit switch, then goes back, and goes to +y but never touch …
-
Hi,
i'm using MKS Robin, and i want to set up a dual extruder on my core xy. I can enable the 2 extruders but i don't know how i set the distance between the Noozls in den Config. In the Machine …
-
When importing the [spreadsheet](https://github.com/dirtdigger/fleur_de_cali/blob/main/Parametric%20Skew%20Calibration.xlsx) into Google Sheets, after entering all the measurements, i noticed that the…