-
Hi,
is it possible to add the DS18B20 Temperature Sensor to the supported device?
I'd really appreciate.
Regards and keep up the great work,
Marco
-
### The problem
More parasitic powered sensors on bus, 1k pull up. Seems like every time after reset it publishes 85. And sometimes repeated bus reset, so one of the sensors has 85˚C all the time.
I…
-
-
Hey!
~~I'm testing this with a `DS18B20` sensor and it does not find it :/~~
Update: setting the board to 80Mhz system clock allows it to detect it, but I get `UnexpectedResponse` in the device ad…
-
Using an Adafruit QTPy ESP32-S2 and Arduino IDE 2.0.0,
DS18B20 non-parasitic, wired with 4.7K pull up on DQ
Compiles & uploads fine but just keep getting the `No more addresses.` message over & over…
-
@iiot2k/node-red-ds18b20
I installed your node, I work great but suddenly i freeze. It stay in ) in may case and the label is gray out, before was black and change 0 to 1, any recommendation is ru…
-
### Description
I am currently working with ESP32-S2FN4R2 on a LOLIN S2 PICO board.
I am using OneWire library to connect DS18B20 (with Rob Tillaart DS18B20 library)... not very original !
…
-
What would you do if there would be more DS18B20 each with their own node N1S1, N1S2 etc.
-
var sensor = new sensorObj.DS18B20(0);
^
Trying to run this code:
var sensorObj = require('jsupm_ds18b20');
/************** Main code **************/
console.log("Initializin…
-
Hello everyone,
I have a De Dietrich MPX 20/24 MI COMPACT successfully connected to a D1 mini 32+diyless master opentherm shield.
Version : 1.4.5
Apartment: attic
Indoor sensor: LYWSD03MMC…