-
Hi, After sending the commands ATZ, ATE1, ATH1,ATAL, ATS0, ATSP2, ATMA Individually, the following do not return an OK.
ATAL no response,
ATMA no response.
Is there something I am doing wrong Per…
-
Hi All,
I have a Skoda Enyaq and the MeatPi works with the CarScanner and I can see SoC and many other values.
I've tried to get any rx data by using the information created with the CarScanner wh…
-
i dont have the yellow display..but i have the 2.4inch spi interface display...is this display compaitable with this project and can you give me the wiring digram
-
Hi! great work here. for my project, i'm using the OBDLink SX as my OBD2 cable ( i'm pretty sure it does support ELM327 and work with same protocols) and i'm connecting it to USB host shield that is m…
-
Hey there Freddy,
First of all, hats off to you on a great project !
So I have been reading up on your project and got myself a cheap Chinese ELM327 pictured as a dual board dongle, but turns ou…
-
Adding support for ELM327 modules
-
Hello,
Just built the cable as per wiki, and it never connects to the ODB interface.
The ELM327 works in my car w. Torque app, but not on my 2011 Sportster 883R.
Any ideas on how I could fix this?…
-
Hi, I have an issue trying to connect to my ELM327 device to my Raspberry Pi 2 running ubuntu mate. The adapter is perfectly running on my Android phone (using torque) and even with the raspberry runn…
-
Hello,
At the moment I'm trying to build a similar project (ESP-32 connected to an ELM327 via Bluetooth) and I was wondering if there's a special procedure when the two devices have never been pai…
-
Loving the idea of this! I will try to install shortly.
Was wondering if its possible eventually to emulate one of the elm327 or some other bluetooth OBD dongle in the future to read car CAN data …