-
The following end print macro is my suggestion. It will not only move the toolhead to a safe position based on what was just printed, but it will also turn off all heaters and motors once it's moved.
…
-
Compare these two delta fans:
https://www.digikey.com/en/products/detail/delta-electronics/ASB02505SHA-AY6B/7491489 (5v from BOM)
https://www.digikey.com/en/products/detail/delta-electronics/AF…
-
Brushless DC fans contain sensitive driver electronics which are not designed to stand up to a high frequency square wave input. The fan output should have an additional MOSFET and a capacitor to make…
-
### Description of the bug
I created a part to focus on the dynamic speed and cooling problems I was having:
![image](https://github.com/prusa3d/PrusaSlicer/assets/100837414/43f4fc31-7df3-4912-bcb…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
I have installed H2-V2S on Ender3 and I have a consideration on extruder design.
To save as much printing area as possible I had to move extruder far to the right and even then I have lost about 10…
-
Hi,
A feature, implemented on the shelly 2.5 in shutter/cover mode was to disable the run timeout with 0 value
It's not possible on the shelly plus 2pm in cover mode
We need that feature since w…
Adefx updated
4 months ago
-
`fan_electric_input_power` was removed from the HeatRejection data group in addressing the Issue below.
[https://github.com/open229/ruleset-model-description-schema/issues/181](https://github.com/ope…
-
When porting over to HomeKit each motor has 4 switches assigned to them 1 Fan and 3 toggle.
-
### The problem
In some cases action "fan.toggle" incorrect sets the fan speed.
- Just after flashing firmware or reset the device the action "fan.toggle" sets fan state to "on" and fan speed to …