-
### Printer model
MK4, XL
### Describe the feature
Basically, users could chose to replace the preheat button with, for example, "set ready". Alternatively, users could add two new buttons to…
-
Pause spaghetti detection on filament runout.
-
Firmware: 1.0.5beta
Currently the filament runout sensor only works for prints from SD card. Octoprint cannot detect runouts.
I don't know much about GCODE but it seems that the M115 command gets …
-
How do you enable use of MT_DET_PIN for filament detection? FIL_RUNOUT_PIN cannot be used because it requires a standard LCD to work. How does filament detection work with MT_DET_PIN?
-
Would be great to have Filament Runout Detection working with OctoPrint. Currently it doesn't send a Pause via Serial to OctoPrint, so it can't be detected.
-
Using Creality CR-10 with EZBoard and Universal firmware.
Performed a filament change, using menu on controller. After restarting, the plugin reported that filament was not moving (though detections …
-
I don't know why, but sometimes the unload fails and I'm sure the synced unload not works if it fails.
It tries to unload to the buffer but the filament is still inside the extruder (toolhead sensor …
-
Today, my QIDI Q1 Pro is consistently reporting the filament sensor as "Off" even though there is filament present. I used the commands ENABLE_FILAMENT_WIDTH_LOG and QUERY_RAW_FILAMENT_WIDTH to check …
-
I have configured by board and connected the Smart Filament Detection Module per the provided instructions in the Github repository, however as soon as the first layer has started it will indicate the…
-
I'm running the BTT smart Sensor v2 on a Voron 2.4 with klipper. When I print things seem to work correctly until some point where the switch sensor gets triggered. When I heat the hotend and extrude,…