-
following error happens when i try to use autotune with fysetc-42HC40-204A-300N84:
`TMC 'stepper_z' reports error: DRV_STATUS: 40150010 s2vsa=1(ShortToSupply_A!) cs_actual=21 stealth=1`
the motors…
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…
-
I failed to build the firmware downloaded from here after i upgrad PlatformIO to the latest version (Core 6.1.3).
It seems that the build-in library of ESP32 cannot be read correctly.
Please help.…
25879 updated
2 years ago
-
Id like to ask you, if there is any compatibility problem to use BTT EBB 2209 CAN toolhead with Spider V3 controller?
I flashed firmware on both (Spider3 and EBB CAN module), controller is normally…
-
I wanted to be able to connect my Fysetc Spider board, stem32, but haven't been able to get the serail ports set up right yet.
-
what type of display to put in the configuration for FYSETC AIO II in Marlin 2 ???
-
I have a bed slinger and have an onboard ADXL345 in the BTT EBB36 canbus setup.
This only gets me X axis input shaping.
I bought the Fysetc PIS to do the Y axis but its unclear in the very limit…
-
Where can I find installation, schematics, etc. V1.3 version of this tool head? I tried installing it using the Fystec SB CAN Toolhead Wiki (https://wiki.fysetc.com/SB%20CAN%20ToolHead/#31-menuconfig…
-
Hi,
I didnt realise there was a difference between BTT drivers and Fysetc.
Can someone please advise what jumper settings i need to use to make these work
![20240704_211220](https://github.com/…
-
Hello,
Is anybody tried this config?
Is it possible?
Is anybody can support me with the connection guide & FW settings?
Skr Pro v1.1 + TMC2209 UART + TFT81050