-
### Describe the feature or hardware support you'd like
Would be a great feature to add support for Skew correction inside klippain. E.g part of the macro START_PRINT.
https://www.klipper3d.org/Skew…
-
**Distribution version. Eg. octopi, armbian**
Raspian 64-bit lite with Octoprint installation.
**Octoprint version**
1.8.6
**An OctoPrint log file. You can access and download it in the OctoPr…
-
I believe the commit at https://github.com/Klipper3d/klipper/commit/faee2c0e52506f157d38b747613df213d659226a
broke compatibility with TMC Autotune. After updating to latest Klipper I started getting…
-
I think this would be a clean way to have curve control for the bed fans if you're already using the chamber_temp sensor for your PTC heater. As of now, a sensor pin needs to be defined for [temperatu…
-
add M600 g-code for filament change
https://github.com/Klipper3d/klipper/blob/master/config/sample-macros.cfg
-
When I level the 3 Plus then it doesn't measure the right side and the back of the bed.
I am not sure why and I checked the printer.cfg and I may found the problem.
All config have these settin…
3Dtcb updated
1 month ago
-
# Proposal: use [multi_pin xxx] in config files
Make use of some multi_pin aliases and/or controller_fan definitions to control fans otherwise controlled by different pins.
There's multiple part…
-
# Re-enable the Artillery Sidewinder X2 Filament-Runout Sensor | freakyDude's Blog
The post shows you how you can re-enable the stock Artillery Sidewinder X2 filament-runout sensor and configure with…
-
Hey Mamsih, would it be possible to add a mount for a sensor to support input shaper on Klipper https://www.klipper3d.org/Resonance_Compensation.html
-
Hello,
Would you like to push your config to the offical klipper repository?
https://github.com/Klipper3d/klipper/tree/master/config
Ideally you could also add values for pressure advance (iirc…