-
When we move the pins for tx, rx and flank detection to PB00 - PB03 (we only need three pins), we have all core pin usage on the top of the chip, so the other three sides are entirely usable for other…
-
When >1 device is on loconet, ln2block does not react to direct address or broadcast messages.
ln2b v2.08/5
1 ln2b + 1 other device > no reaction
2 ln2b (different lncv[0] ) > no reaction
1 ln2b =…
-
Selection of long or short address should be removed in configuration panel.
On Loconet only short adresses are used for range 1..127. Long adresses are not supported in this range.
The option i…
-
Hi Geert, I built your device, but after some settings of the pins, the fields are disabled,
only the field "Device" and the next field on the right of the button "Reset Device" are enable.
The titl…
-
there is no EX-Fast_Clock.ino file to download.
-
Is there a way to build a basic version of the circuit on a breadboard using an ESP32 board (e.g.
ESP32-DevKitC) and a L298N board without (much) extra components?
If so, would it be possible to …
-
```
08:33:28.759: [[195ebf3b] 00 00 01 00 00 02 00 01] R: 02.01.57.20.00.32 - 00.00.00.00.00.00 TractionControlRequest set fn 2 to 1
Src: Throttle test
08:33:29.323: [[195ebf3b] 00 00 01 00 00 0…
-
Hi Geert,
In mijn zoektocht naar een mooie zelfbouw oplossing voor het digitaliseren van mijn modelbaan was ik bij jouw LocoNet_IO uitgekomen.
Echter zie ik dat je die repo nu opgedoekt hebt en do…
-
It seems not very practical to have to use computer with JMRI for connection to the Train command station. There might be several ways how to use the wiFRED operating on WiThrottle protocol, either us…
-
Hi, this is not real issue,
Me and Paco F. Canada just spend some time playing with Uhlenbrock packets well known as LNCV. In reality used for lot of occasions, for example additional data about lo…