-
Even the controller is initialized and communication is shown in the log the current pool and spa temp only get rarely updated.
It turned out that the temps are updated when receiving the heat status…
-
When I compile the Pentair driver it does not want to compile and this is the following error.
In file included from C:\Users\Matt\Documents\Arduino\libraries\Pentair/Pentair.h:10:0,
…
-
### Feedback
First sorry in advance if I'm missing this, but I have the screenlogic controller configured with a remote access password and the integration fails to log in. I cannot see anywhere t…
-
Thanks for all your help so far. A feature that would be helpful is to add the time sync feature that is available in the pentair application. While I want to place most of my automations in HA, a few…
-
**Describe The Bug:**
I have a set of pre configured pool pump speeds used by the pentair intellicenter schedule, they show up as "features", they are : pool slow, pool medium, pool high and pool h…
-
Awesome code! It was my first time using ESP-IDF, so that was a bit of a learning curve. But once I got the code compiled, the code read all of the states and sent them to home assistant through MQTT …
-
At present, add-on sees my heater (Pentair UltraTemp ETi Hybrid Heater) but the control is limited to the temperature setpoint. The "operation" field of the add-on shows options for: heater and off. T…
-
Hi, Thanks for this awesome project.
Wanted to see if you could give me a hand. Have a couple of issues.
Using Pi Zero WH + the USB connector cable you specified in the Wiki.
1. I'm not seein…
-
Thank you for this HACS integration. Do you plan to have support for pulling the last Chemcheck pH and Sanitizer readings? Currently I can see when the Last Report was taken.
-
Looking through the readme, I dont see what sensors it will create. I'm looking to be able to control the on/off state on my pump as well as changing speeds through intellisync. The integration does…