-
Hi,
i can control my hoverboard using the PWM commands but i fail to get the speed reported correctly. When using a positive PWM value, i get a negative speed reported and when i use a negative PWM…
jpiat updated
4 years ago
-
```
17:28:34.751 -> rst:0x8 (TG1WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
17:28:34.751 -> configsip: 0, SPIWP:0xee
17:28:34.751 -> clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00…
-
Hello!
- orange pi zero h2+ 512mb
- Armbian_23.11.1_Orangepizero_jammy_current_6.1.63
I installed wiringOP like this:
```
git clone https://github.com/orangepi-xunlong/wiringOP.git
cd wiring…
-
I'm getting an error every time i try to extrude filament
```
Unable to obtain tmc extruder phase
TMC 'extruder' reports error: DRV_STATUS: 40140020 s2vsb=1(LowSideShort_B!) cs_actual=20 stealth=…
-
Temmuatlut thanks for the hard work on this library.
I'm working with the 5160 BOB and while testing settings to evaluate what I want to use on my 3d printer I noticed some of the commands for 5160…
-
IRSend - commands are received on my Roku about 1 in 3.
Instrument to measure ISR latency & jitter for 50us ISR.
Measure IR output for frequency and duty cycle.
If bad,
Is there a better wa…
-
## Steps to Reproduce:
Follow the [official instruction](https://docs.px4.io/main/en/advanced/gimbal_control.html)
1. Set `MNT_MODE_OUT=AUX`
2. Set `MNT_MODE_IN=Auto`
3. Configure Gimbal Servo u…
-
ARDUINO IDE 2.3.2
TFT_eSPI ver: 2.5.43
Board "Lilygo T-Display s3" selected
[CustomFont.zip](https://github.com/user-attachments/files/16323284/CustomFont.zip)
Compiler gives error :
C:\Users\sal…
-
----
### Issue
Hey everyone I’m trying to use mavros for control t200 thruster(pwm), I’m using ros2 and I’m using the topic of overrideRCIn but when I run this nothing happened, the thruster do…
-
The Argon One V2 revision 06122021V4.2 fan speed can be set with I2C write commands with value between 0 (off) and 100 (full speed). There is almost no difference in fan speed between values 1 and 100…