-
Hi guys,
I just broke my foot and I have a lot of time on my hand.
I am a bit of a jack of all trades, I can code and have some electronics basics.
My guess is, since ESP8266 and ESP32 share a…
-
The idea is to use a Raspberry Pi (_or Arduino_) to power the RFID Reader for the Door(s).
The Raspberry Pi Zero W has the following _advantages_:
+ Cheaper (_**£9.16** per board_) ... see screens…
-
Hi, finally I decided to make custom PCB because previous version of my build was horrible "tangled cables" style horror and I was scared about safety because there weren't any fuses and so on... Here…
-
Would it be possible for the Wiegand reader to get outputs for LEDs, green and red, and a buzzer?
From an accepted reading, the green LED would light up for the set time and the buzzer would give a …
-
I am trying to get this [access control device (125Khz)](https://www.aliexpress.com/item/32849704134.html) to work.
I've tested the code on [another device (13.56Mhz)](https://www.aliexpress.com/it…
-
Hello,
There are Wiegand Readers, that also have Fingerprint Modules, like [this](https://de.aliexpress.com/item/33056522572.html?spm=a2g0o.productlist.0.0.5b4c606eV2rGHo&algo_pvid=b098170a-89be-45…
-
Hi,
i am using version 1.02 with a rc522 reader.
I hide an esp-rfid reader in the charger housing of my vaccum robot one reader on each floor to identify on which floor the robot is docked for l…
-
Have possible give somehow direct card code reverse example 9B3FAA, AA3F9B?
Need new part to software? Example wg.getCode (), HEX / wg.getCodeinv (), HEX
Some reader give data reverse.
-
just pulled the latest repo and noticed it no longer displaces the correct format for HID C15001
```
[ Proxmark3 RFID instrument ]
[ CLIENT ]
Iceman/master/v4.14831-916-g429139f17-dirty-…
-
Hi, looking for a way to implement gatw access using 868mhz fobs, will this system work with those if the fob receiver uses weigand?
Thanks, Tim