-
Just a quick question. I notice that 2.4.3b9 gives the option of converting to RTCM 2 but when I try this the output is RTCM 3. Is this something that is likely to be implemented soon? I am particular…
-
Hi All
I tried to compile the 'testeph' directory using the included 'makefile' on Linux. I get:
[amuls:~/amPython/RTKLIB/util/testeph]↥ master(+1/-1)* ± make -n
cc -c -Wall -O3 -ansi -pedanti…
-
Hello all,
I'm having problems getting a fix with 2 ublox neo mt8 sensors. I'm sure I'm doing something wrong but I can seem to find what. After 30 minutes the solution status is still float.
Thank y…
-
In 2015 the RTCM SC104 committee decided to add some message IDs for experimental uses, with the general goal was that all new messages would be developed using these ID would in time be given a final…
-
I've successfully compiled in OS X 10.12.3 (Sierra) using -lSystem.B as suggested in this issue: https://github.com/tomojitakasu/RTKLIB/issues/137. However, when I try to run rnx2rtkp I get "Segmentat…
-
1. Not obtain position solution from ublox m8t using rtknavi in windows platform.
2. In rtkrcv , it shows ./rtkstart.sh: permission denied.
Command execution error: ./rtkrcv.sh (32256)
Rtk server …
-
Good morning.
I wanted to ask if you can give me an updated list of the best components (Hardware) to buy to carry out the project.
Best regards
-
When converting RTCM data in `convbin`, or `rtkconv` the modification time of the file is used as the start time. However, if `-te` is set and its value is less than the modification time of the file,…
-
I'm struggling with setting up an RTK solution for Pixhawk.
Please help!
This is my config:
BASE:
U-blox NEO M8T (NEO-M8T Time & RAW Triple Band +HMC5983 Tallysman TW2710 for RTK)
Setup in U-center se…
-
I am using a ublox [NEO 7P](https://www.u-blox.com/en/gps-modules/neo-6p/neo-7p.html) chip with an [ANN-MS](https://www.u-blox.com/en/positioning-antennas/active-gnss-antennas/ann-ms.html) antenna fix…