-
Hello,
I trying to adapt the edge branch of g2core to my Arduino Due shield which controls four stepper driver (St L6474) via SPI.
I found the Motate submodule is many commits behind its master bran…
-
Offer support for USB device and host.
Define a coherent USB HAL + a reference driver. Rp2040 or SAM3x seem good candidates.
The USB HAL would ideally make a TinyUSB port to picoRTOS easy
-
**_Reported by Piotr Mienkowski:_**
I would like to propose to streamline/rework/clarify usage of GPIO, Pinmux driver combo which I believe become overcomplicated and may be confusing for a regular u…
-
ERASE_CMD on the Sam3x is left floating in the existing hiduino firmware, which causes the Due to nuke it itself randomly.
Reference https://github.com/arduino/Arduino/blob/ide-1.5.x/hardware/arduin…
-
I was wondering if the SAMD51 might be an interesting target for the future?
It is also a SAM architecture but based on Cortex M4, its cheaper and seems more "powerful" than the SAM3X the Due uses.
…
-
### Description
Hello Mr.engineer,I need your help. I encountered a problem while testing 'hello world'.
https://opentitan.org/guides/getting_started/setup_fpga.html#manually-loading-fpga-bitstreams…
-
The idle task should be use to mange house keeping that has no set run point and management of what level sleep sates we can enter in order to try and save battery power
I need to re read some FreeRT…
-
[Mega](http://arduino.cc/en/Hacking/PinMapping2560), [Due](http://arduino.cc/en/Hacking/PinMappingSAM3X), etc. The pin mappings are different, the registers are different (and a lot more of them on t…
-
**_Reported by Piotr Mienkowski:_**
I would like to propose to streamline/rework/clarify usage of GPIO, Pinmux driver combo which I believe become overcomplicated and may be confusing for a regular u…
-
Newbie to CPU programming here. I'm trying to use the SAM3X's low-power backup mode to reduce energy consumption on my Due. One of the ways that the CPU can be woken is with an interrupt signal from t…