-
I am trying to communicate two devices. One broadcasting based on Ra-02 Aithinker SX1278 433MHz using arduino-LoRa library (demo sender).
https://www.disk91.com/2019/technology/lora/first-steps-with…
-
Hi,
I have TTGO T-Beam V1.1 which has SX1262 LoRa module.
The module fails to initialize and isn't supported with the builtin templates.
To make a long story short, here is how to solve it (not ele…
-
I've been testing your library on a SX1262 and I've seen that method 'setTxPower' fails for values lower than 14dBm.
I'm new at programming but I think that, on file "SX126x.cpp" -> void SX126x::set…
-
Error if send from bluetooth: failed, code -705
Receive not work (len off)
My config
```
#ifdef ESP32_DIY_1W_LoRa_GPS // My Ebyte E22 400M30S OR RA-01S / SX1268
#define OLED_SDA …
-
With a working 1W custom ESP32/LoRa board now (thanks to you & Bob-N6RFM!), I noticed that the default tinyGS "Power" parameter (5 dbm) did not take advantage of this device's power output capability.…
-
Hi!
Your code is great. Did you ever tried to use it with newer SX1268 modules? I'm not sure if I pick one of these SPI modules or the UART version which are easier to work with, since SX12xx have m…
-
Congratulations on the project
Does the it support the new E22-400T**33**S due to increased consumption?
https://www.ebyte.com/en/product-view-news.html?id=454
-
Could we have support for ESP32-S3. Heltec Lora V3 is using -S3 version of ESP32.
j0uni updated
11 months ago
-
The pin allocations for the simulator are;
#define RADIO_DIO0 2
#define RADIO_DIO1 3
#define RADIO_BUSY …
-
Hello @tapparelj
I am testing your software decoder for LDRO enabled Transmissions and found out that the output is erroneous and garbled. I have also attached the recorded transmission for your t…