-
For the pcb/components/wiring part:
https://upverter.com
The hardware github.
nofxx updated
8 years ago
-
I'd love to see the ability to program the fuses for the relatively new tinyAVR 0/1/2 and Atmega series (like mega3208/09, mega4808/09, AVR128DBxx. I use AVRDUDESS regularly for "mass" flashing (haha,…
-
Maybe not an issue, but why do you do this?
```
/* Enable all UPDI port pull-ups */
PORT(UPDI_PORT) = 0xFF;
```
```
/* Enable all LED port pull-ups, except for the…
-
Hi,
I can Flash and read the FUSEs but when I try to set a fuse it always fail with the error below.
```
ze-mac:device ze$ pyupdi.py -fs 0:0x00 -c /dev/cu.SLAB_USBtoUART -d tiny202 -b 115200
Dev…
-
Hello,
Is possible to support the attiny1614 more (ram/flash) ?
I get errors in make because the "USB_INTR_PENDING_BIT":
sbdrv/asmcommon.inc: Assembler messages:
usbdrv/asmcommon.inc:99: Error:…
-
Hey there, after suffering from a severe case of NIH I've decided to write some assembly for the ATtiny1614: https://www.microchip.com/wwwproducts/en/ATTINY1614
It's not directly listed in avra's d…
-
Hello,
I would like to know if there will be support for the following devices:
ATtiny424,426,427
ATtiny824,826,827
ATtiny1624,1626,1627
ATtiny3224,3226,3227
Thanks
-
It would be good to adopt avrdude 7.1 release.
Reference: MegaCoreX has adopted avrdude 7.1 release.
https://github.com/MCUdude/MegaCoreX
mcuee updated
4 months ago
-
1. The recording address of SIGROW_DEVICEID[012] is different for AVR_EA and AVR_EB. Therefore, you need to create separate binaries for each.
2. CLKCTRL of AVR_Ex is equivalent to tinyAVR/megaAVR se…
-
Randomly, the firmware will refuse to boot, rendering the device unusable until a re-flash is done.
Flash dump indicates that the firmware is still in flash, unmodified and uncorrupted.
T_RST pi…