-
Hi! I am trying to convert Fujitsu (General) AC split system (DC Inverter type R410( to air/water heat pump. I have an outdoor unit without indoor unit. Do you thinks it's possible to use this code f…
-
I try to install 7.4.2.0 on the Sonoff dongle E over the web interface but getting an after completing 100%
```2024-04-30 14:13:15 emscripten universal_silabs_flasher.xmodemcrc[42] DEBUG Firmware u…
-
### Problem Description
I was trying to set microphone input gain on ES8388. I noticed that I am having I2C communications errors at the end of the setup:
```
I2SCodecStream i2s_st…
-
## Expected Behavior
link on 10Gb optical ports
Link lights show while booting
## Current Behavior
In boot process sfp+ ports link lights work then go dark
I’ve tried a numbe…
-
I recently got a 2F-85 Gripper, and I'm trying to get to work via USB/ROS. My Issue Is similar to the ones described #45 and #121, but I followed all the steps and i can't seem to get the gripper to …
-
I have been searching with google trying to find information with **examples** that contain the exact bytesequence what is send over the serial intrface to the GRBL-software.
I **have** read this d…
-
**Describe the bug**
I am a newbie with MacOs (before I worked with gphoto2 on Ubuntu and Rasbian).
When I installed (brew install gphoto2) I am able to take photo only with sudo (not with ordinar…
-
I decided to try installing openipc on my old Foscam (FI9821W V2.1, HI3518CV100). While following through the instructions, I made it as far as flashing the u-boot image (https://github.com/OpenIPC/f…
-
I've been software testing this port of GRBL on the teensy3.1 . My hardware is disconnected at the moment and I've been using https://github.com/winder/Universal-G-Code-Sender because it's complete, …
-
can you add the display and menu like ttgo t display and replay signal easyley or design like fliper zero by display its very dificult to work with this device
soryy about my request ..ithink its …