-
Hi!
I have exactly the opposite problem that this project solves..
I recently bought a broken fanatec CSW V2.0 wheelbase and fixed it, (so it seems)
but, I don't have a fanatec steering wheel, and …
-
Using Debian Buster, Marlin at commit c28e08c8, running an SKR v1.3 with a brand new RRD 12864 display (BigTreeTech red PCB model with contrast pot, via normal cables that needed no twisting/flipping/…
-
## Current Behavior
My Matek F722-SE with uart GPS & I2C compass works perfect on Betaflight target MATEKF722-SE. Had several flight sessions today, and decided to try INAV leaving all the wiring a…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
My BLTouch works perfectly and deploys and retracts on command but during g28 it will not deploy
/**
* Marlin 3D Printer Firmware
* Copyright (c) 2019 MarlinFirmware [https://github.com/MarlinF…
-
cc @rust-lang/release
-
New thread.....
-
Currently, Home Assistant users use the Openhab MQTT template changing the Controller Subscribe and Publish.
As stated in home assistant documentation:
https://www.home-assistant.io/components/sens…
-
## Arrays
```
homie/super-car/$nodes → "lights[]"
homie/super-car/lights/$name → "Lights"
homie/super-car/lights/$properties → "intensity"
homie/super-car/lights/$array → "0-1"
homie/super-c…
-
Hello,
For the last 10 days or so i have been extensively and happily using my imax b6 80W charger with cheali-charger-Dual-Power-B6AC-80W-RC_2.00-e10.3.12-20160613_atmega32.hex. During this time i…