-
I'm using https://github.com/shishu94/Klipperotchy/tree/main/tools/serial_moonraker_bridge
My setup: P3 Pro -> USB A to USB C cable -> Female USB C CH340E -> Male USB A CH340G -> RPi 4
Both USB t…
-
In the guides, you state:
"Before starting, verify whether your chip is STM or GD. You can do this by either opening your electric box and checking manually, or by navigating to 'Machine -> System …
-
Please see here.
https://github.com/pedrolamas/klipper-preprocessor/issues/12
In Cura......
I have some groups/assemblies. If I want to cancel one ideally it should show as a single 'object' …
-
I'm planning on reusing the spool registered in spoolman instead of creating a new one, since I usually forget to set which spool is loaded (even harder with multi material) I just configured custom g…
-
Hi!
I'm having this problem a while now. After some 'fault' event on HH (filament Runout, gate empty, etc..), my systems starts an MCU shutdown in all MCU's, usually starting by EBBCan (toolhead MCU)…
-
I have tried and tried to install multiple instances and cannot get it to work. I use KIAUH and once i delete klipper , moonraker, mainsail, and crowsnest it will not allow me to add klipper back on a…
-
### Cura Version
5.4.0
### Operating System
Windows 11
### Printer
Flsun Sr
### Reproduction steps
1. sliced stl
2. upload to printer via mainsail
3. when print starts with purge line it ret…
-
Hi. I want to connect a common 100k NTC in PC1 & PC2 in my spiderboard 2.2. But in mainsail it shows to high temps about 80 degree instead 20(room temp). In the other thermistor slots works as spected…
-
If I start a print job using HH and for some reason print is paused (ex: clog or load/unload error), after solveing the issue and resume print job, everything works and print job is done until the end…
-
I just tried out the Orca Slicer and it has a really useful feature the device tab which I can monitor my print from the slicer. It appears to y a web browser extension that makes it possible to view…