-
Hi,
I am currently setting up rtabmap in ROS with a RGB camera + 3d lidar sensor + IMU.
My problem is that the map is drifting after just a few seconds. See image below (supposed to be a wall on…
-
```
What steps will reproduce the problem?
1. rc522_reader seems to "hang" after the first match of a id in
/etc/RC522.conf
2.
3.
What is the expected output? What do you see instead?
I would expe…
-
```
What steps will reproduce the problem?
1. rc522_reader seems to "hang" after the first match of a id in
/etc/RC522.conf
2.
3.
What is the expected output? What do you see instead?
I would expe…
-
```
What steps will reproduce the problem?
1. rc522_reader seems to "hang" after the first match of a id in
/etc/RC522.conf
2.
3.
What is the expected output? What do you see instead?
I would expe…
-
```
What steps will reproduce the problem?
1. rc522_reader seems to "hang" after the first match of a id in
/etc/RC522.conf
2.
3.
What is the expected output? What do you see instead?
I would expe…
-
Thanks for the firmware! I'm using it on `rpi_pico` board with `swd` and `set_clock` features enabled.
During exploitation, I ran over a problem, when a probe stops servicing.
To reproduce I'm co…
-
Using Rigol DS1054Z oscilloscope to measure the PWM output, I found to get 50.0hz, I had to set HardWarePWM to 46.7hz.
Setting function to 50hz, which is what is expected for SG-90 servos (really 20m…
-
**Describe the bug**
The SDHCI controller gives the error "mmc3: error -84 whilst initialising SD card" when it is connected to the microSD Card slot (by using the 0xfe2000d0 bit1 mux). This is robu…
-
hi,
thanks for the burnLVP project. Being in a scripting language makes it easy to modify.
i was able to use it to burn PIC4550 using Rpi.
i then started to see if i could use it to burn the PIC usin…
-
In the `Get started with MicroPython on Raspberry Pi Pico' book there is this great explanation of the SPIx_Rx and SPIx_Tx nomenclature:
>SPI TERMINOLOGY SPI requires four connections: one that tak…