-
Hi, Using 4.3.9 Configured with the online configurator. Have 2 nozzles set up by adding the following to configuration_overall.h
#define SWITCHING_NOZZLE
#if ENABLED(SWITCHING_NOZZLE)
#de…
-
**Right Now I have use your X-scara firmware.I know how to set INVERT my motor but I confuse what is the correct direction.I test on Pronterface and Repetier-Host.My Question is**
![move_in_position]…
-
1. One case of slip in X-Axis. Plan to reduce micro-stepping in hardware and firmware. Reduced micro-stepping to 1:8. Still had one slip. -- This might be because of insufficient strength of build-…
-
pbbob updated
6 years ago
-
Hello
i getting error when trying to upload the code?
i guess its this initial_value: '${end_position}'
any fix?
-
I was able to attach my PandaPi to my Openbeam Kossel Pro, and all that's left is configuration. However, whenever I run G33, it consistently errors out with either "homing failed" (if I don't home fi…
-
I upload the codes correctly. But I can not send the G code because there is no connection the grbl controller (3.5.1) and arduino. How I can fix it. If I use another software to connect arduino for s…
-
### Did you test the latest `bugfix-2.1.x` code?
No, but I will test it now!
### Bug Description
I have had Marlin 2.1.2.4 working on my printer fine with A4988 drivers , but just replaced the step…
-
I try to send a file (a g-code) using web ui, but it is not able to write sd card (trying with differents sd card)....transfert is shown completed (100%), but no files are on the media, althought I ca…
-
Checking the documentation, there is none for version 1.2. The motion controller mode also appears selectable via solder pads on version 1.0, but there is no reference as to where those pads are on t…