-
- [x] Enable the RX driver for the clock.
- [x] Add More Radio, update footprint for connector.
- [ ] Filter capacitors on the ANTENNA_BIAS voltage
- [ ] Trace impedance calculations (50 Ohms for A…
-
```
What steps will reproduce the problem?
1. Use r1.1 code with default voltage reference (1.1V)
2. Use a Witespy KV modded minimOSD board (22k/1k dividers)
3. Increase GUI calibration to max (255)
4…
-
In some cases, a piece of supporting information is provided along with the published article. These do not have a separate DOI but can be found on the same page where the main work is published.
M…
-
The doc infrastructure should be the same between ecto and the kitchen so we don't have impedance mismatch.
-
Why Fmu mcu communicate with Io mcu series 220 ohm ?
for impedance matching ??
-
When USB is disconnected (as-in, no USB power applied, not talking about opening/closing the USB serial port here), the 16u2 is powered down. In this mode, it seems it does not put its outputs in high…
-
### Discussed in https://github.com/AUTODIAL/AutoEIS/discussions/18
Originally posted by **tappanbr** September 17, 2023
Hello! Thank you for making AutoEis. When trying to use it, I was not a…
-
How can I configure pyEPR to assign boundary conditions other than PerfE? e,g. an Impedance Boundary
-
See discussion in https://github.com/mne-tools/mne-python/issues/12861#issuecomment-2361102202
-
Hi, I'm using PrawnBlaster to generate pseudoclock for my NI 6535 board. The clock terminal is set to PFI4 by
```Python
NI_PCIe_6535(
name='ni_6535', parent_device=master_clock.clocklin…