-
Hello. How can I get the thread function on an ESP32 with TB6600 drivers. I also have optical encoders to monitor the rotation of the shaft.
I just flashed the firmware I saw that the thread funct…
-
## Here are the steps I follow to reproduce the issue:
1. Try to use G76 in lathe mode with Gmoccapy
2. With following gcode
%
(M14X1)
N10 G7
N11 G18
N12 G90
N13 G21
(THREAD1)
N14 M0 (…
-
What i want is scale Laser power down while accelerating / deccelarating. I think this would solve the problem of deeply burned edges and other small figures.
It can be easily done in st_prep_buffer()…
-
### Description
Hello everyone - I am submitting this as a bug because I truly do believe it is a marlin-specific bug. At our shop, we are currently dealing with a number of large-bed printers. We …
-
stop doesn't seem to be immediate, hold is though. If you are in a hold state and you stop it get stuck in a hold state and you have to reset.
In the other senders I believe stop will be immediate…
-
Hello @terjeio
I would like to ask you for the handling with M6 Commands in the G-Code.
I didn‘t test it in your Software, but I know the Workflow in the old Software that I was using.
In the So…
-
I have implemented three new tool change options and would like some input on what I have done and if it makes sense.
See the [Wiki page](https://github.com/terjeio/grblHAL/wiki/Manual,-semi-automa…
-
Any plans on ability to generate lathe cnc toolpaths?
That would fill a void in the opensource / freely available segment.
korpx updated
4 years ago
-
Hello,
Would it be possible to add support for stepper motors in the code?
The faulhaber motors are difficult to find here in Brazil.
It could add support for a second mass air flow sensor to m…
-
### System information
SolveSpace version: 3.0-7f9117b2bf0
Operating system: Fedora
### Expected behavior
When selecting "force NURBS surfaces to triangle mesh" for a helix extrusion I tho…
kalle updated
4 years ago