-
I am trying to get this camera ([https://www.amazon.com/SainSmart-Fish-Eye-Camera-Raspberry-Arduino/dp/B00N1YJKFS](url)) working with libcamera. It is working with old stack (raspistill, raspivid), so…
-
Hi Bryan!
I found your post at https://theoreticalideations.com/2013/05/10/node-js-raspberry-pi-aquarium-awesome/ and I think this is an awesome project! I just recently purchased my own 75 gallon ta…
-
Please edit this template and fill out all the information you can (where relevant). Failure to provide essential information can delay the response you receive.
* **I'm submitting a ...**
- […
-
I cloned RC6 and then used a diff tool to carefully copy over only the relevant configs from my RC3 Configuration.h to the RC6 Configuration.h and uploaded to the arduino board on the printer (using A…
-
Update to RC6, everything uploaded fine, it just won't connect. Tried Repetier Host and Octoprint.
Appears to be a Marlin-specific issue, if I install Repetier Firmware, I am able to connect without…
ghost updated
2 years ago
-
Cannot get the Buzzer to chime when sending M300 S1000 P1000.
The buzzer works with the LCD button press, but will not work with M300.
Any ideas?
-
Hi all.
I want to compile the firmware for my sapphire plus with 1.2 board.
I double checked the preconfiguration which is needed and not able to figure out where is the problem.
`
Marlin/src/…
-
Hello. After G29 command not working raise between probing points. I don't understand why or what wrong I do?
Marlin 1.1.0-RC7
This is my configuration.h:
``` cpp
#include
/**
* Marlin 3D Pr…
-
Using the latest build and when I issue a G28 command to home all axis the autobed leveller servo tries to swing down but crashes into the edge of my bed and will not trigger. The Z axis is still tryi…
-
Hi, I did this post on the reprap forum, but after a couple of posts nobody seems to find an answer for this strange behaviour:
http://forums.reprap.org/read.php?13,358655,373531#msg-373531
The thin…