-
We are using the gr-iridium module with a USRP X310 and an ANT500 antenna in an open field environment. We are able to receive and decode some messages from time to time, thus we assume that the overa…
-
Is it possible to send the audio stream into JAERO from a ZMQ pub sink in GNURadio? Or is there another way to send data from GNURadio into JAERO?
I am currently sending some data from a pub sink a…
-
HackRF works as a receiver. How to measure the Eb/N0 of the received signal?
How could I get the BER curve?
How to do the synchronization so that we could calculate the error bits?
Thanks!
-
Hello, In example wifi_tx.grc , I want to know whether the duration of WiFi packets during transmission can be controlled through existing parameters (e.g. samp_rate, pdu_length, interval)?
Thank y…
-
Hello @bastibl
I've been working on a project, and for various reasons, I'm unable to obtain the exact IQ data point shown in the constellation diagram. The flow diagram for wifi_rx is as follows:
…
-
An enhancement to FoxTelem is requested, that the program would be able to be called from the command line in batch mode to process an audio file. The GUI might or might not display, but no further i…
-
I want to set AX5243 in DBPSK 100bps at 868M on a 200KHz bandwidth and receive continuously, is it something possible with your implementation?
Also, is there a way to set the preamble (19bit in my c…
-
I made a scheme in GNURadio with Soapy BladeRF and try to compile but I have an error
**Generating: '/home/ground/Documents/GNURadio/bpsk_BladeRF.py'
Executing: /usr/bin/python3 -u /home/ground/…
-
Hello,
I wanted to verify the direct TX1A to RX1A wireless link. I am sending a stream of repeated data on the 'dac_data' bus (modified the 'tx_intf' module and added the ILAs on 'dac_data' and 'ad…
-
Hello!
Full simulink model of QPSK receiver available?
AXI QPSK Receiver: Coarse Frequency Sync simulink model not simulate.
ghost updated
3 years ago