-
**Question**
How do i get the Switchbot meter device to get discovered properly by esp32-ble-mqtt?
**Additional context**
I have 3 switchbot meter devices. These devices are broadcasters that rep…
-
With the new RAPI API to pause OpenEVSE LCD controller updates it would be possible to alternate the LCD display between the standard LCD display (session energy & total energy) from the openevse cont…
-
### Board
esp32 dev module
### Device Description
esp32 devkit c v4
### Hardware Configuration
* I2C sensors
* I2C display SSD1306
### Version
v2.0.2
### IDE Name
VS Code + arduino-cli
### …
-
i am working on esp8266 connected to aws iot ,My project is to control lamp through esp8266 so after reading what should i do for getting the response from get/accepted shadow
i have to send empty p…
-
My issue is a bit different to wifi disconnection. Occasionally I take my raspberry pi based MQTT broker offline to backup the SD card. As a result of the broker going off line for such an extended pe…
-
Hi,
I've run your broker on my esp and it works fine. I can use i.e Chrome's MQTTLens extension, subscribe to topics and receive messages, but when I try to use the [client you've linked in the read…
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
Manjaro linux AUR and Hass.io
**ESP (ESP32/ESP8266, Board/Sonoff):**
ESP32 but I don't think the board is relevant
**E…
-
Это переходная версии с старой за 2017 год, на новую 2018 года.
Если вы не выполните обновление, то следующие обновления вам станут недоступны (ESP зависнет при обновлление).
На что нужно обратить…
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.2.24
### Description
Publishing on mqtt using TLS runs briefly (under a minute), then stops publishing. It appears to be a memory i…
-
I am using an ESP-01(AT command set) connected to an arduino Meg2560 using hardware serial at 115200 baud. It was fairly easy to get it to connect to WiFi using WiFiEsp.h & to an MQTT broker but I hav…