-
#### What were you doing?
Loading gcode print (gcode was generated by Simplify3D)
#### What did you expect to happen?
Print to load without warning message (bounding box of object is 70mm x 70mm …
-
Currently it appears to just guess how much time is left based on bytes of gcode? Which is wildly inaccurate unless you are printing an object that is very uniform in shape and print speed. Ideally it…
-
Branch: master, Commit: b168ef7e7451bb12eea36bd8376bc7edd5243bc7
Terawatt is running multiple instances of the Octoprint server from one RPi in order to control multiple machines. Usually things wor…
-
When I go to gcode viewer tab I dont see the gcode platform. I found that is somewhere out of the window and if I press the left mouse button and drag down I can finally see ithe platform, but next ti…
-
Is it possible to increase the minimum amount of time the step pin is held in a low state between steps? I'm seeing that it is sometimes low for only 1us, particularly at higher speeds. I believe th…
-
Hello: I am trying to install opencamlib on max osx high sierra using homebrew. The installation fails during cmake. I am trying to use 3d surface command in freecad 0.17 as installed on the mac. I…
-
I installed it by "pip install pymuv". And then I key "mandoline-py d.stl
`'mandoline-py' is not a code..`
When I cd the mast dir of the source file, I test by "python stl_normalize.py", and the…
-
Please provide *general* feedback on your experience with the 1.3.5rc1 Release Candidate here. An "All is working fine" is valuable feedback as well, because it tells me that people in fact are testin…
-
Please provide *general* feedback on your experience with the 1.3.5rc3 Release Candidate here. An "All is working fine" is valuable feedback as well, because it tells me that people in fact are testin…
-
I keep getting this error "raise OSError("No memory to allocate with /dev/vcio")". What can i do to avoid getting that?