-
Using the Waveshare 1-channel CANbus Hat 8 MHz HAT (the RS485 CAN HAT to be more specific, https://www.waveshare.com/wiki/RS485_CAN_HAT) on VenusOS 3.11, I get a lot of errors when connecting to my Py…
-
### Describe the bug
Meine Wallbox "openWB series 2" reagiert nicht auf die Änderungen (Stop/PV/Min+PV/Schnelladen).
Getestet mit openWB Software 1.9.303.0 und 1.9.304.0.
Die Kommunikation mit d…
-
### What happened?
I just set up openDTU on Battery on an openDTU Fusion board, used to control a Hoymiles HMS1600.
When I set up the Dynamic Power Limiter (Target Power to 30). But when it starts…
DerWe updated
4 months ago
-
My recent install of batmon-ha on a standalone Raspberry Pi is working reliably but doesn't survive a reboot after a power fail.
Logging on to the Pi and running:
sudo systemctl status batmon.se…
-
### The problem
Nach Update auf 2024.2.0 bzw 2024.2.1 funktioniert die Gardena Integration nicht mehr
### What version of Home Assistant Core has the issue?
2024.2.0, 2024.2.1
### What was th…
-
Hi,
I use [irekzielinski](https://github.com/irekzielinski) [Pylontech-Battery-Monitoring](https://github.com/irekzielinski/Pylontech-Battery-Monitoring) solutions since years at 2 different locati…
-
**Describe the bug**
I have the Controller Board connected via CAN to my Inverter Deye SUN-12K- SG04LP3.
For the communication I have choosen the PYLON protocol in the diyBMS Controller.
My Inverte…
-
### Is there an existing issue for this?
- [x] I have searched the existing issues
### Current Behavior
There will be multiple enhancements suggestions. Therefore they'll be marked with & and…
FajnB updated
10 months ago
-
Hi, just trying to set this up - very excited to make better use of the BMS. I am using an ESP32 and changed Serial1 to Serial2 (the board i have Serial1 is attached to an OLED display), comms estab…
-
Hello,
I love your project. I ordered the pcb and started soldering. I also checked for the 120 Ohm on the 485_2_TTLs.
But I don't understand what are the connectors U4 (Sensors written on the PCB…