-
**Case 1**
I was using Arduino Uno in the following way. The IR LED was used for Transmission/Receiving signals. It worked well.
:
```
group: National\ Transformation\ v2_0 {
dimensions:
parameter = 4 ;
…
-
Hello,
Excerpt: LIN_ADVANCE on delta slows down print, breaks print and gives a lot of "humming" an all steppers while printing.
Long:
I did a switch from repetier firmware to marlin 1.1.1 be…
-
STEP 0: Pick a Target; closest creature in firing arc. If there are none, then the closest creature.
STEP 1: Use any ability that occurs during the Planning Phase, if possible.
STEP 2: Use any abili…
-
Hi,
I m having some troubles to setup grbl-mega-5X on my MPCNC.
All movements are alright but I can't get homing to work. When I home only 1 motor per axis is moving.
In config.h I have 2 axis pe…