-
Hi there
I wanted to test the MSP over SPORT function with my OmnibusF4 FC to configure PID settings with my Taranis. But no values will be displayed. Telemetry seems to be ok, cause I get voltage,…
-
Enabling serial comms on current version 1.13 allows some data to be read over serial (specifically attitude and current rx settings), but does not support writing writing rx values (for example setti…
-
Hello
is something planned or in progress for FlySky i-Bus telemetry ?
-
Thanks for putting this up to date page and your wiki page explaining how to install the firmware.
However, I've found nothing on how to connect the LRS JR module to the Taranis.
I have the DTF-UHF …
-
Hey, i tried to upgrade my omnibus f4 yesterday, i used `dump` to find the firmware ( OMNIBUSF4 in my case ) and i launched the flash. Everything is working perfectly execepted the blackbox. I can't c…
-
If select Sbus receiver on UART1 not activated integrated signal converter and must be used external converter. Thanks for repair.
-
Hey so I can't send RC commands but I can set motor values because I dont have DYNBALANCE included. Since I am using cleanfliht and not MultiWii code, where should i comment out "#define DYNBALANCE" i…
-
I think it's time to think about designing a FC specifically for INAV.
Features I want to have on this FC:
1. Future-proof design with an F4 (or even F7) CPU
2. 8 outputs supporting 8/0, 6/2, 2/6 mo…
-
- Seen in version (release version or githash):
All
- On flight controller (if applicable):
All
Issue details:
FlySky i-bus protocol is not available under serial port options. No FlySky i-bus p…
fujin updated
8 years ago
-
Hi,
there seems to be an issue with the PPM-in using th heratbeat pin in the module bay (X9E at least).
I was using the famous DIY-headtracker for a while on my old Taranis and it worked fine. On th…