-
**CONTENT WARNING: copious amounts of rosin in pics below**
First of all, thanks for making this keyboard available. It's been an amazing, albeit very long journey getting all parts and fitting every…
-
### Development Kit
openocd-esp32
### Module or chip used
Beetle ESP32-C3
### Debug Adapter
usb-jtag
### OpenOCD version
v0.12.0-esp32-20241016
### Operating System
linux
…
-
### Describe the problem
When a debug session is active, the upload fails. This is expected, but it probably has to be better communicated to users.
### To reproduce
- Start a debug session,…
-
The G2 I tested with is an LX100 variant, and during flash readback or programming, it drops Vref on the JTAG thus the programming fail. Has programming of the LX100 Pano with standard 14.7 and DLCP9 …
-
### Board
esp32s3
### Device Description
esp32s3 devkitc n8r8
### Hardware Configuration
Native USB port plugged into computer, serial convert USB port not plugged in.
### Version
…
-
Hello,
When I try to debug a STM32H743ZI CPU with Mbed Studio, it fails.
```
0000700:INFO:ap:AP#2 IDR = 0x54770002 (APB-AP var0 rev5)
0000703:INFO:rom_table:AP#0 ROM table #0 @ 0xe00fe000 (desig…
-
the raspberry pi python program (TAPASstart) doesn't seem to enter the while-loop in the identification mode.
"while ((ret["flags"] & (1
phdaf updated
6 years ago
-
I am trying to use SWD on a Pi Pico W, which uses a standard 3-pin header. How can I connect Tigard to this SWD port? **The docs used to say that SWD can be used on the JTAG header...** is this not th…
-
@cerna
https://github.com/machinekit/mksocfpga/pull/115/checks?check_run_id=1294764215
AFAIK someone pulled the plug on the old build system a while ago and
someone is yet to place in the replac…
-
If a hart makes a bad memory access and the bus blocks, the debugger can't halt the hart (depending on the debug module implementation). This currently leads to "Unable to halt hart " and OpenOCD abo…