-
**Describe the bug**
"Cat Napping": **No yellow highlighted** blocks to indicate new added blocks **in hint of the first 9 steps**
**Steps to reproduce the behavior**
1.Navigate to https://makec…
-
This situation usually occurs when I write programs that are quite large and have many Jacdac modules connected.
when I press reset, it should operate normally again.
Error Code is *^*980
ht…
-
**Describe the bug**
In getting started, we link via bit.ly to a knowledgebase article on support.microbit.org
This link no longer exists and should go to https://microbit.org/guide/swift-playgrou…
-
**Describe the bug**
**Open Instruction in** editor Help doc which is **a wrong place**
**Steps to reproduce the behavior**
1.Navigate to **https://makecode.microbit.org/beta**.
2.**Radio Games…
-
Hi I have been attempting to flash the OpenHayStack Firmware onto a nRF51822 chip, and everything went well until the final step when I try to deploy the image.
Steps to reproduce the behaviour:
…
-
With a micro:bit V2.2 running 0256 or 0257:
- Connect a battery pack
- Connect the USB cable
- Open MakeCode or the Python Editor
- Connect via WebUSB and flash
- Disconnect and reconnect the USB…
-
Problem One:
I choose "No Pairing Required: Anyone can connect via Bluetooth" to make my microbit program.
The same program have different conditions on microbit v1 and v2.
https://drive.google.com…
-
**Describe the bug**
**Hint** shows crashed after dragging **tutorial content** downwards
**Steps to reproduce the behavior**
1. Navigate to https://makecode.microbit.org/beta#
2. Open any tutor…
-
With V1 it gives:
```
ERROR thonny.plugins.micropython.backend: ManagementError while handling get_object_info
Traceback (most recent call last):
File "/home/annamaa/python_stuff/thonny/thon…
-
Hi,
With `sudo -H pip install pyocd`, I get
```
lockheed:~ simon$ pyocd-gdbserver --version
0.10.0
lockheed:~ simon$ pyocd-gdbserver -l
0 => Microbit [nrf51] boardId => 9900023432044e450017801…