-
I was thinking about changing the Nema11 with hollow shaft to a different angular positioning system.
It seems to be very difficult to find such a motor here in Brazil, so I'm planning on using the s…
-
Is there a way to run two nema stepper motors at the same time?
I'm trying to run two Nema stepper motors, not BYJ motors.
the BYJ motor has a code that turns two at the same time. Is it impossibl…
-
I want to use 2 Nema17 step motors.
Send signal from Arduino board to A4988 or TMC2208
next
Signal transmission from A4988 to Nema17 stepper motor (first motor)
I want to receive an input signal f…
-
Now that Input Shaper and ADXL support has been given heavy attention for the past 6 months or so, it seems like it wouldn't be too difficult to mount the accelerometer to a toolhead and use it for Z …
-
- [x] Arduino Mega
- [x] 6 Nema17 4401
- [x] 6 Drivers A988
- [x] Filament impresora 3D PLA, 1,75mm 250g
- [x] Webcam
-
A great project in advance! Is it possible to use a stronger engine? I wanted to automate external blinds with it. (In principle, the same system but only with a cord) The 5v engine is a little too we…
-
During testing with A4988 stepper driver + 24BYJ28 12V stepper motor, it seems the DIR pin is not changing direction properly. This resulted in random shifts due to skipped steps or moves in the oppos…
-
**Motherboard Revision:** REV04
**Enhancement Description:**
- Move to on board drivers being TMC2209 or better at the date of this enhancement.
-
In the past I noticed how printing at 8 mm³/s with my hot end caused thinner extrusion width than expected along long straight walls or infill. Now I find this video demonstrating scientifically t…
-
### Bug Description
I’m using X axis to turn a wheel. So I’m trying to move the wheel little by little with distance between the stops of around 8mm (measured on the outer radius of the wheel).
Wh…