-
### TFT Version
4.3.11
### Firmware Version
4.3.11
### Blueprint Version
4.3.9
### Panel Model
EU
### What is the bug?
Is saving preferences to flash every second necessary?…
-
I guess the RX TX line needs to be switched in the schematic:
![image](https://github.com/user-attachments/assets/ecfef443-f52c-4b14-9782-30a0fe7c1d85)
RX needs to be connected with TX of the di…
-
In my version of IDE (OSX) I see two minor inconveniences; imho it would look slicker and cooler, and be easier and more intuitive to use, if these were fixed.
1) in the scrolling text frame at bo…
-
### TFT Version
4.3.9
### ESPHome Version
4.3.9
### Blueprint Version
4.3.9
### Panel Model
EU
### What is the bug?
So I updated the panel to the latest fw yesterday over ota (from 4.3.7, esp…
-
I purchased a new ESP32 DOIT DEVKIT. Used the pio run -t upload and pio run -t uploadfs commands to upload the current sketch and preferences. Both were successful. Nothing was connected to the ESP32 …
-
My setup:
- RPI 3B
- Pi-Star:4.1.7 / Dashboard: 2024010 (clean and fresh install)
- ZUM Radio-MMDVM for Pi v1.0 (HRO white PCB) (presently has as purchased FW: MMDVM:20190130)
- 64GB new SD card …
-
Hi,
I'm using mk4duo 4.3.2. I have a bltouch clone. I set it up as blotuch sensor (couse if not, then it leaves the tip out when moving the next calibration point).
Sometimes when measuring a ca…
-
### The problem
I'm trying to compile a customized version of NSPanel for Home Assistant. This is the code:
### Which version of ESPHome has the issue?
2023.11.6
### What type of installation …
-
### Description
I implemented the driver using the example in the README. When I touch my screen, I don't get a call on the callback.
### Reproduction Steps
1. Use example code.
2. Upload sc…
-
Using latest build 4.3.9
Have rocking hotend and using Dondolo dual extruder Bowden . (Hotend 1 to the left, z probe in the middle and hotend 2 to The right).
Dondolo servo index is 1, the other "…