-
Below is the Data from opening and closing the door after 2 sec 3 times in 10 sec intervals.
The opening is easy, but there is no (consistant) signal when closing the door, the 3rd try even crashed t…
-
Hi there,
I'm trying to configure this plugin in my Homebridge installation on a Pi 4b. I have connected a Arduino with RFLink which is connected to the confirmed `/dev/ttyACM0` port.
When I tri…
-
I`m just discovering the existence of LoRa and have bought an RFM95 and connected the following pin-out
`
PI Port RFM95 Port
3v3 = VCC
GND = GND
GPIO10 = SPI_MOSI = MOSI
GPIO9 = SPI_MISO = MISO
G…
-
I try to list here hardware which could be used for tests, proof of concept, etc.
DIY-Tracker: http://wiki.glidernet.org/ogn-tracker-diy
- 32-bit CPU: STM32F103
- RFM69 or RFM95 RF chip
- almost…
-
Hello,
thanks for you your wonderful library.
I was looking to grab and reproduce the commands of this remote in order to automate them in an Arduino/Pi/Nodered infrastructure.
https://www.habita…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
The frequency of 433.92 can be received by the receiving end of 433.92, or it can be received by the receiving end of 868, and the analysis is successful,,for rc-switch
-
Hi!
I used to have pimatic running in the past (also contributed some code) but am now a Home Assistant user. I still have a Homeduino laying around which I would like to use to receive some signal…
-
Hi I am very interested in this project.
I come from currently using the Mysensors library with the RFM95 Lora on 433MHz.
I would like to support this project and try out with testing as soon as p…
-
Hallo Suat,
ich bin nicht so vertraut mit Git und pull request, daher hier mein Vorschlag in der rc-switch library in Zeile #48
ICACHE_RAM_ATTR durch IRAM_ATTR zu ersetzen. Wieso? Ich bekomme bei…