-
Current implementation of $G (View gcode parser state) always returns spindle state M5 (hardcoded here:
https://github.com/Smoothieware/Smoothieware/blob/573ed7c0c719008075acb1d36850e718a2707372/src…
-
Suggestion
The Large Processing Factory does:
Compressor
Lathe
Polariser
Extractor
Fermenter
**Distillery**
I'm not sure why it would have Distillery as that is already covered with the Di…
-
MANY, OR, OPTION, etc all say "using the short form is recommended as it will compute the lookahead function automatically. however this currently has one limitation: It only works if the lookahead fo…
-
Salve, uso la mia lingua ma se è un problema posso ttradurre..
Situazione: bCNC con GRBL ver 1.1 su Arduino Uno r3 e CNC shield
La CNC è una stampante 3D traformata, con piano di lavoro che si muove…
-
When building the machines, everything works fine, but when leaving the game and re-entering later, they stop working or they do it randomly.
I have not been able to figure out what produces it, but …
-
I flashed this firmware at my mega2560 ramps1.4 board, successed, and connected with grbl control .It shows error 9 when I try to move any axis. What's wrong?
-
@jameskolme If you actually need that sort of formatting it's not that hard to add. The old .txt was an export from Embroidermodder which I neglected to port. If you'd use G-code instead I'd have to k…
-
The issue is that the normal for the prism bezier spline is reversed from all other spline uses in both lathes and prisms. See the attached tarball for the README, test cases, some pre-rendered.
[P…
-
Hi
It is a difficult job to add a lathe mode for Cetus ?
I have try to read source code but i have short knowledge with programing, so if you does not want to make the necessary amount of work m…
-
Currently the internal representation of axis positions looks like so:
```
typedef struct {
double x, y, z; /* this.x, etc. */
} PmCartesian;
typedef struct EmcPose {
PmCartesian tran;
…