-
what if I am using px4? I do not have Qualcomm Snapdragon
-
Hello @terjeio ,
As I now finished my machine which has two motors for the Y-Axis, I start thinking about the possibility of squaring the gantry while Homing.
Do you think this would in the futur…
-
Hello Everyone
I wish desperately to install Slic3r, Printrun and Octoprint on Raspbian, but impossible to install Slic3r Pe .
I followed the instructions of this link: [How to install Slic3r on RPi…
-
Maybe it's a problem, now I have an alternative solution but I leave the restlessness.
https://forum.xod.io/t/different-result-simulation-vs-debug/3384
-
I have had a quick look at some 64x64 P2.5 panels and discovered there is an additional decode line 'E' on the HUB75 interface. This is pin 8, which is currently pulled to ground on the Raspberry Pi …
-
The Electrical Engineer will be primary motivator and contributor to the analysis, conceptual design, development, and testing of electrical circuit boards, cables, power supply box and wiring harness…
-
The Embedded Systems Engineering role will specifically encompass the creation and technical application of embedded firmware for the operation and support of metering systems having FPGA architecture…
-
Hi all, what I am doing is a bit unorthodox, but should work in GNS3, as it works in the bridged network outside of it - I am attempting to run a custom qemu build for the xtensa platform with support…
-
---
Author Name: **Oleg Rodionov**
Original Redmine Message: 3087 from https://www.veripool.org
---
In my vcs simulation model, for certain, simulation content, I see majority of simulation time…
-
Hi everyone,
So I've forked @thinkyhead 32-bit branch and started to work on an ESP32 implementation. The code isn't functional yet, I got the very basic code working to get it compiled + uploaded …