-
Running ip_repo_gen.tcl then openwifi.tcl leaves two unconnected inputs on the openwifi IP. They are dma-valid and dma_data[63:0].
These two inputs were not on the openwifi IP for the zed board so w…
-
0. Could you send email to xianjun.jiao@ugent.be to introduce your self?
1. Our image is used directly or you build your own image?
2. What is your own modification?
3. Versions: OS, Vivado, …
-
When I clone master branch directly, and following the README to use ip_repo_gen.tcl to generate project will report error.
But if I clone master branch user --recursive parameter, the project wil…
-
Hi xianjun, I am using the IQ capture program to collect Wi-Fi packets. I am confused by the definition of capture interval N in the command 'side_ch_ctl gN'. Is it the interval that FPGA board perfor…
gxhen updated
2 years ago
-
I appreciate your work very much. It's excellent.but I have some problems.
My openwifi device is adrv9364z7020,the openwifi version is v1.3.0.
I set the sdr0 monitor mode by './monitor_ch.sh sdr0 …
-
Hi Dr Jiao,
Could you please tell me whether Openwifi supports stand-alone operation? That is, I would like to process CSI using the ARM core onboard instead of transmitting them to a PC with an Et…
gxhen updated
2 years ago
-
hello, My own board is based on xc7z030 , and i have done some modification for my board:
1. Modify the DDR configuration and MIO constrain. The same constrain is been tested for another SD card, whi…
-
The module of axi_ad9361 has four channels of enable and valid signal output. What is the function of these signals? If I set all these signals to 1, can the module work normally?
-
From Eugene Liu:
Hi, I am looking to do some experiments with SDR using openwifi on Analog Device adrv9364z7020 hardware.
I am studing channel estimate. From the csi document, 11a/g only 48 s…
-
Hello, now I need to change the SSH IP address( default 192.168.10.122) ,bcause the ip address has conflicted. So, how to change the SSH IP address? Looking forward to a reply,thanks!