-
I'm having issues getting the bright pi working with octoprint. I've build the bright pi per the instructions and have installed the RPi.GPIO library, enabled I2C in RASPI-CONFIG and rebooted. Then di…
-
### Describe the problem/bug
DS18B20 Temperature sensor stopped working overnight and got stuck at 0C. Config page for w1thermsensor shows two "00-00000000." device ID
Tried a config page for OW-S…
-
### Describe the bug
Hi there, I am trying to install the drivers to use a respeaker 6-mic array in a jetson nano, but it is not working. It is connected using the 40 pins.
I have tried to use these…
-
Hi,
I was just wondering if it is possible to use your work for CC1101 chips that are mounted on a USB board (UART ) with a silabs cp210x chipset?
I would like to use such a RF transiever on my R…
-
#### Type of Raspberry Pi
RPi 3 B+
#### Linux Kernel version
Linux raspberrypi 4.19.57-v7+ #1244 SMP Thu Jul 4 18:45:25 BST 2019 armv7l GNU/Linux
#### Expected behaviour
The examples on…
-
Hi, I receive the following error in my log:
`
Nov 11 20:10:30 unipi Node-RED[341]: 11 Nov 20:10:30 - [red] Uncaught Exception:
Nov 11 20:10:30 unipi Node-RED[341]: 11 Nov 20:10:30 - TypeError: m…
-
After starting OH snapshot 3556, all bundles are active except one:
```
40 x Starting x 80 x 5.12.1 x com.sun.jna
```
Is there a problem somewhere ?
-
Please see the article here -- http://wiringpi.com/news/
Any chance MMM-LocalTemperature will be updated to work around this issue?
-
# Describe the issue
When a new bank or preset is added to a LV2, webconf does not show this in its presets list. Refresh of page does not work. A restart of the webconf service is needed before the …
-
Hello, here is my solutions for upgrading the low cost white mmdvm dual hat pcb with failed to init device message:
Both of them need litle solders!
1st solution with a stlink usb adapter:
…
F1RVC updated
8 months ago