-
The issue is that the normal for the prism bezier spline is reversed from all other spline uses in both lathes and prisms. See the attached tarball for the README, test cases, some pre-rendered.
[P…
-
Hi
It is a difficult job to add a lathe mode for Cetus ?
I have try to read source code but i have short knowledge with programing, so if you does not want to make the necessary amount of work m…
-
Currently the internal representation of axis positions looks like so:
```
typedef struct {
double x, y, z; /* this.x, etc. */
} PmCartesian;
typedef struct EmcPose {
PmCartesian tran;
…
-
The way the G-code interpreter is integrated into task is seriously convoluted and suggests reconsideration.
This document describes the status and issues: https://github.com/mhaberler/asciidoc-sandb…
-
I am preparing to get GRBL running for my milling machine and think it will work great, but the lathe is another story. Since threading on a lathe is a relatively common operation, I don't see being a…
109JB updated
6 years ago
-
I was using 0.7.1 before and getting almost perfect results in mach3. Ive now upgraded to 0.9.9 and the amount of options are awesome in expert mode but I cant use it because G0 causes a dwell or paus…
-
## Here are the steps I follow to reproduce the issue:
1. Start LinuxCNC using sim axis.ini
2. Power on and home the machine
3. Open a terminal and if needed set up the RIP environment
4. La…
-
Mike (@magman2112) and Simon were raising concerns about the floorboards today, saying that various need replacing, even the new boards Mike reckoned could be done better with reclaimed boards. For fi…
-
**Application Version**
3.31 and also 3.0
**Platform**
Mac/Linux
**Qt**
N/A
**PyQt**
N/A
**Display Driver**
N/A
**Steps to Reproduce**
1. Use STL from [thingivers…
-
The DRO plugin is doing double duty right now by showing active endstops, machine state and the latest comment. It also doesn't show all status information.
bCNC and GrblPanel both have nice little…