-
Adding a OLED display device to ESPEasy causes parentheses error on the json page.
"Sensors":[
{
"TaskNumber":1,
"Type":"Gases - CO2 MH-Z19",
"TaskName":"CO2",
"TaskValues": [
{"ValueNumber…
-
// scroll down to the end. The problem was fixed. But there are still two error messages.
Some results from the latest version:
- Messages from the serial gateway didn't seem to result in any acti…
-
Hello!
I'm trying to read mhz19 co2 sensor data using ESP12F with micropython.
My pins are connected as following:
MHZ19 ESP
GND --> GND
Vin --> Vin
Tx --> Rx
Rx --> Tx
Co…
-
The MH-Z19 sensor transmits over mqtt always "U = 0.00".
The line with the "U" can not be removed either.
14:26:35 ESP-206/PPM 594.00
14:26:35 ESP-206/MHZ19Temp 22.20
14:26:35 ESP-206/U 0.00
-
Сергей, снова обращаюсь к вам за помощью.
Решил нарисовать эл. схему своего макета. Мне понравился ваш стиль схемы, сделанный в Fritzing, - наглядно и информативно. Начал искать для этой платформы…
-
If
user_config.h
// #define USE_MHZ19 // Add support for MH-Z19 CO2 sensor (+2k code)
// #define USE_SENSEAIR // …
-
Originally reported by: **laurinaitis (Bitbucket: [laurinaitis](https://bitbucket.org/laurinaitis), GitHub: [laurinaitis](https://github.com/laurinaitis))**
----------------------------------------
…
-
With the current mega version, a rule with %systime% will no longer be executed.
It still worked until this morning.
Did you change that?
It is this part:
on green do
if %systime%> 08:00:00 a…
-
With the current Mega Branch, the time query is again not executed.
The source from yesterday worked fine.
I had not changed my rules.
I just flashed the version from yesterday - it works.
-
Make sure these boxes are checked [x] before submitting your issue - Thank you!
- [x ] Searched the problem in issues (https://github.com/arendst/Sonoff-Tasmota/issues)
- [x ] Searched the problem…