-
Processing esp32 (platform: espressif32 @ ~4.0.0; framework: espidf; board: esp32dev)
--------------------------------------------------------------------------------
Verbose mode can be enabled via…
-
I'm thinking of setting this up on a common 3D printer platform (Arduino Mega 2560 + RAMPS 1.4 + LCD w/ SD card reader), and I'd like to make it run standalone (like Marlin does).
So, I figure I'm …
-
pin connection are
SCLK is IO18
RST is connected 3.3V
MOSI 23
MISO 19
CS is 32 so i have add this line
ADS8688 bank = ADS8688(32); // Instantiate ADS8688 with PIN 32 as CS
when I am cha…
-
Win 10 x64 PixMax 720
From the docs its says to select 'Inkcut Generic Driver' if my device isnt listed.
I then selected the interface type, serial, as per the spreadsheet linked from the docs.…
-
As discussed in https://github.com/corrados/edrumulus/discussions/139#discussioncomment-9177871 direct very hard piezo hits on my MPS750x sometimes cause no edrumulus MIDI output.
In fact, there ap…
3hhh updated
6 months ago
-
M10CUBE format CNC Brakeout Nucleo64
-
#### Do not use to discuss topics!
**Describe the bug**
A clear and concise description of what the bug is. Which components of eModbus did you use?
When using the ModbusServer TCP WiFi library …
-
I have a board that has two native `can` interfaces `canC` and `canE`. The board receiving navigational data from `nmea0183` over serial. This may be re-transmitted and used in widgets without problem…
-
Hello,
I am trying to run the following tutorial : [Deflection of a Membrane](https://jsdokken.com/dolfinx-tutorial/chapter1/membrane_code.html) ; but it throws a compilation error at jit level. I th…
-
Hello,
before, I wish you a happy new year!
I use the Arduino DUE with GrblHAL and if I want to work with GRBL-Plotter, I get the message "RESET - waiting for response of grbl controller" and the …