-
I recently got an Ender 3 V2, but one of the stepper motor drivers on the motherboard is broken. I have an old ender 3 running SKR mini E3 board and works pretty well, so is the new SKR mini E3 V2 boa…
HYC23 updated
7 months ago
-
Hi, i am using 4 motors for Z axis (Nema23)
and i am using TMC5160 v1.2 for all 9 drivers and with 128 microstep
TMC5160 is capable of 4.5Amp, and My NEMA23 motors are 4A/phase
after starting 5 min…
-
I am retrofitting a Creality Cr-X with an SKR 1.4 board. I have triied just about everything here guys. here is the problem, I cant home the the print head. i have an skr 1.4 and im running marlin 2.…
-
Can't get my E0 - E1 to work
I have received 2 death 2130 drivers, so i am trying to run my SKR 1.3 bort like..
```
#define X_DRIVER_TYPE TMC2130_STANDALONE
#define Y_DRIVER_TYPE TMC2130_STANDAL…
-
I would like to use this firmware for my custom 3D printer, however I was looking at using H-bridge motor drivers instead of the traditional direction/step motor drivers to drive bipolar stepper motor…
ghost updated
9 years ago
-
In the example Stridemax_dual.cfg it appears that pins
spi_software_mosi_pin: stridemax_dual:**gpio4**
spi_software_miso_pin: stridemax_dual:**gpio3**
are incorrect per your pin out diagram of th…
-
Hi there,
I searched all issues, I couldn't find or I missed my problem.
Are there any response message or alarm message if stepper driver got thermal shutdown?
Thanks.
-
I just received the MKS DLC with the TFT24 LCD panel and the S109 drivers to use on a laser engraver but I can't get the stepper motors to move.
When I connect with a computer, I can access the RGBL …
-
What is the status of this driver?
- Is it working for both servo and stepper motors?
- Any known issues?
- What models does it work with?
- Are there plans to move it to the epics-motor proje…
-
Ok, I'm sorry if this isn't exactly at the level of most people on these forums but here goes :)
I'm making an SLA DLP printer with a Nema 17 stepper motor and a projector.
I've downloaded photo…